BRAVO HF 0.15

USE

It is an ideal solution for microbiological protection and protection against viruses in water. The appliance can be installed under the kitchen counter and is intended exclusively for drinking water or water used in cooking. The drinking water purifier consists of a double housing in which two quality filter cartridges are installed.

DESCRIPTION

It is an ideal microbiological protection of water against: E.coli, Salmonella, v. Cholerae, Legionella, viruses and at the same time retains all solid particles larger than 0.15  mcr. The insert allows a flow of approx. 4 m3 of water, then it must be replaced with a new one. The inlet and outlet connections of the water purifier are R 1/4.  

​

• ​ the first filter cartridge is mechanical with a permeability of 5 mcr. It is intended for protection against sludge, various sediments, sand, rust and against all solid particles in water larger than 5 mcr.

​

• The outer part of the second filter cartridge is made of activated carbon (sintered carbon block) 0.6 mcr. and is designed to protect against: chlorine, pesticides, insecticides, improves the smell and taste of water and retains all solid particles larger than 0.6 mcr. The inner part of the insert is made of hollow capillary membrane fibers 0.15 mcr.

​

​

​

KIT CONTAINS

• double filter housing,

• mechanical filter insert 5 mcr.

• filter cartridge CA - SE HF Pb– U SX with activated carbon and hollow capillary membrane 0.15 in the middle  mcr.

• wall filter bracket

• wrench for tightening and unscrewing the filter pot,

• screws for screwing the filter holder to the filter head.

• stand-alone faucet,

• manifold with valve,

• and pipelines.

​

MAINTENANCE AND INSTALLATION

The inlet and outlet connections of the water purifier are R 1/4. The mechanical filter cartridge must be replaced every 6 months. Filter insert CA - SE HF- U SX 0.15  mcr. however, it is necessary to replace it every 6 months or at least 4 m3 of water used.

​

Water filters made of plastic and brass and components of these materials which come into contact with drinking water shall be manufactured in accordance with Directive 80/778 / EEC for consumption and production procedure.

CONDITIONS FOR OPERATION AND INSTALLATION

​

• Connections  with: 6.35mm (1/4 ''),

• Operating temperature: 4 ° C-45 ° C

• Max. working pressure at cold water: 7 bar

• Minimum operating pressure: 2 bar

• Sealing: O-ring

• Insert type: SX